Thingiverse

Device to repair a plastic hanger

edmo
170
Downloads
4242
Views
Published on December 1, 2011
This thing was Featured on December 2, 2011

Description

Because hangers cost $1.00, and the plastic to fix them is less than $0.01. Design is intended for PLA. Additionally, this can be used to justify the expense of your 3D printer to your significant other, provided you have several hundred broken hangers.

Instructions

This is intentionally a little bit smaller than the hanger diameter. I'd recommend that you clean it up, drop it in a cup of water, then stick it in the microwave for a minute or so. After it's softened up, press it on the hanger and hold it in shape until it hardens.
Tags
This Thing has no tags.
Report as inappropriate

You must be logged in to post a comment.

3dfuture on January 29, 2012 said:

I have featured this in my 3D Printing Blog - thanks mate! http://www.3dfuture.com.au/201...

edmo on January 29, 2012 said:

I appreciate that. Thanks!

Skimbal on December 2, 2011 said:

I absolutely love your documentation. If only all instructions could take the form of smiley faces.

Collections

View all
Lome Depot
by ibudmen

Remixes

Made

View all

Liked by

View all

License

Device to repair a plastic hanger by edmo is licensed under the Attribution - Non-Commercial - Share Alike license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag.

More from edmo

⇪