Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Motor mount for Brooklyn Aerodrome Towel RC plane
12
Likes
440
Downloads
1251
Views
Published on December 11, 2011
Description
Prototype mount for a TowerPro brushless motor intended for Brooklyn Aerodrome's Towel RC plane design.
Instructions
Build instructions for the Towel are available on the Brooklyn Aerodrome site:
brooklynaerodrome.com/build1.html
This part is a drop-in replacement for the motor mount described in the above instructions.
The dxf file has a drawing of the TowerPro plate for which the mount was originally designed. Change the dims there for alternate plates and recompile the OpenSCAD model. Additionally, there is a "margin" parameter in the scad file if the plate is just a bit tight.
You'll have to drill out the bolt holes on the mount face for the plate; the set screw locations were different relative to the mounting holes for each of the four motors I have, and I wanted them to be in an accessible location once the mount was attached to the Towel deck.
brooklynaerodrome.com/build1.html
This part is a drop-in replacement for the motor mount described in the above instructions.
The dxf file has a drawing of the TowerPro plate for which the mount was originally designed. Change the dims there for alternate plates and recompile the OpenSCAD model. Additionally, there is a "margin" parameter in the scad file if the plate is just a bit tight.
You'll have to drill out the bolt holes on the mount face for the plate; the set screw locations were different relative to the mounting holes for each of the four motors I have, and I wanted them to be in an accessible location once the mount was attached to the Towel deck.
License
Motor mount for Brooklyn Aerodrome Towel RC plane by technophobe is licensed under the Attribution - Share Alike - Creative Commons license.
More from technophobe
You must be logged in to post a comment.