'The Bus' - A VW Bus Pinewood Derby Car
by Skimbal, published
Description
'The Bus' is sized to fit over the block of wood that comes in the pinewood derby kit. It also uses the wheels provided in the kit.
You can also print out you own wheels and use a block of scrap wood to complete 'The Bus'.
Recent Comments
view all
I would print this on a Makerbot in a hackerspace, which mean I would have to pay by the minute. I would love to make this, but I don't know if I can afford it. How long will it take to print everything out?
Thanks.
hi! i need your help! can you plese email me
biotomaz "at" gmail.com 8-)
it didn't seem to cause a problem when printing. In my experience as long as the bridging surface is flat in the Z dimension and well supported at each end, the makerbot wont have an issue.
Tags
License
Give a Shout Out
Instructions
2)Cut pinewood derby block so it fits into space inside bus body.
3)attach wheels.
4)Race, fueled by gravity and Hippie Power.
Comments
You must be logged in to post a comment.
hi! i need your help! can you plese email me
biotomaz "at" gmail.com 8-)
How did it print the window frames with nothing under them?
it didn't seem to cause a problem when printing. In my experience as long as the bridging surface is flat in the Z dimension and well supported at each end, the makerbot wont have an issue.
very nice bus skimbal - thanks for sharing
I am near KC in Eudora . . .
I would print this on a Makerbot in a hackerspace, which mean I would have to pay by the minute. I would love to make this, but I don't know if I can afford it. How long will it take to print everything out?
Thanks.