Modified emaker huxley wade bowden connector part
12
Likes
143
Downloads
1328
Views
Published on December 15, 2011
Derived from
eMAKER Huxley
by jmgiacalone
Description
I wanted a screw fit into a 1/8 BSP push fit for my bowden cable, and this solves it nicey.
Basically the updated wade for emaker, but the bottom is extended and features a hole for 1/8 bsp screw 4mm push fit pneumatic conector. A slot for a 1/8 nut (5.5mm thickness) is made so that the push fit screws into this.
Basically the updated wade for emaker, but the bottom is extended and features a hole for 1/8 bsp screw 4mm push fit pneumatic conector. A slot for a 1/8 nut (5.5mm thickness) is made so that the push fit screws into this.
Instructions
Print.
Aquire a 1/8 BSP pneumatic push fit connector to fit 4mm OD tube (99p off ebay)
Aquire a 1/8 Nut (5.5mm width) (£2ish for 10 off ebay) - contact me as i have spares if need be)
Slide nut into groove
Screw 1/8 BSP pneumatic fitting into nut
Fit bowden tube
Print and marvel at the awsomeness
Aquire a 1/8 BSP pneumatic push fit connector to fit 4mm OD tube (99p off ebay)
Aquire a 1/8 Nut (5.5mm width) (£2ish for 10 off ebay) - contact me as i have spares if need be)
Slide nut into groove
Screw 1/8 BSP pneumatic fitting into nut
Fit bowden tube
Print and marvel at the awsomeness
You must be logged in to post a comment.
License
Modified emaker huxley wade bowden connector part by Roboteernat is licensed under the Creative Commons - GNU GPL license.
More from Roboteernat
Also where do you get the PTFE Glue and PTFE tubing you need in Calgary??
the PTFE Tube can be found from many supllies, try emakershop, ebay or places like Parker or other pneumatic/liquid push fit suppliers. The PTFE glue, well, i dont use it so not sure why you would in this instance. however it is available, a quick google searchin uk came up with this http://www.amazon.co.uk/CLEAR-... so try this o other brands :D