Sort By
ipodholderupdated.stl
51 kb /
133 downloads /
2 years ago
ipodholderupd...gcode
420 kb /
143 downloads /
2 years ago
Ipod stand by Conrad2468 is licensed under the Attribution - Creative Commons license.
© 2009 by Conrad2468
Instructions
MAKE SURE YOUR PRINT HEAD IS CENTERED!!!!! if it isnt then your print will go off the edge. If it goes off the edge a little it will be fine. I also recommend using my Gcode because it has all of the settings "honed" down to where it wont glob up on the thin parts and there isnt a raft. but if u feel that your settings are superior to my setting then by all means try it.
TIP: if it wont stick, preheat the build surface.
