Printable Bobbin Caddy
18
Likes
309
Downloads
308
Views
Published on January 2, 2012
Description
I made this for my wife to keep her thread bobbins in order.
It has a divided pen holder area in the center.
I added four 624 bearings underneath to let it spin.
If you print this i'd love to hear about it.
UPDATE:
I added the .blend file for anyone who wants to play around.
It has a divided pen holder area in the center.
I added four 624 bearings underneath to let it spin.
If you print this i'd love to hear about it.
UPDATE:
I added the .blend file for anyone who wants to play around.
Instructions
Print.
Printed ok on my rep-rap with 0% infill, will go with >20% next time as some of the edges fell in a bit.
Optional:
Install 4 624 bearings with M4x20mm screws. I recommend rubber bands or slices of tubing to act as tires.
Printed ok on my rep-rap with 0% infill, will go with >20% next time as some of the edges fell in a bit.
Optional:
Install 4 624 bearings with M4x20mm screws. I recommend rubber bands or slices of tubing to act as tires.
You must be logged in to post a comment.
License
Printable Bobbin Caddy by ocularb0b is licensed under the Attribution - Share Alike - Creative Commons license.
More from ocularb0b
I had to do a quick filament change mid-print. At 60mm/s this was a rather long print, it took me around 6-7 hours. Looks great though!
very nice! It's definitely a big print, over-nighter. You made the swap in a good spot i think, im yet to give that a try. Hope you like it, let me know if it you find any short comings in the design