Cable Grommet for Desk or Dry-lining (parametric)
11
Likes
296
Downloads
551
Views
Published on January 3, 2012
Description
Having mounted my LED television on the wall I have a 80mm hole behind the TV, through which all the cables arrive. No-one can see it of course, but I know it's there and it needs finishing, otherwise I might start muttering incoherently.
It was designed in openscad and is fully parametric, it could doubtless be used for other purposes, including a desk grommet.
Features
• Fully parametric
• Adjustable to fit any hole
• Parameters includes choice of 4, 2 or 0 clips
• Two part cap for easy insertion of cables
• Cap and Grommet are in separate modules (within the same scad file) so easy to print separately
It was designed in openscad and is fully parametric, it could doubtless be used for other purposes, including a desk grommet.
Features
• Fully parametric
• Adjustable to fit any hole
• Parameters includes choice of 4, 2 or 0 clips
• Two part cap for easy insertion of cables
• Cap and Grommet are in separate modules (within the same scad file) so easy to print separately
Instructions
Open scad file and edit with the measurements for your grommet, compile and export as STL, then convert to gcodes in the usual way and send to your 3D printer.
The two halves of the cap seem to stick together slightly, but I found it easy to separate them.
The two halves of the cap seem to stick together slightly, but I found it easy to separate them.
You must be logged in to post a comment.
License
Cable Grommet for Desk or Dry-lining (parametric) by chrisjrob is licensed under the Attribution - Share Alike - Creative Commons license.
Small lips like that are usually ok to print, I've seen it in other working designs.