Downloads
Sort By
MB-rrmbv12-6d-v...hex
72 kb /
25 downloads /
5 months ago
3G 6D.xml
10 kb /
27 downloads /
5 months ago
They Like It
3G 6D Shield by cpt_caveman is licensed under the Attribution - Share Alike - Creative Commons license.
© 2012 by cpt_caveman
Instructions
0. Install the attached firmware
1. connect up the uglier cable hack (shown in the picture)
Stepper Driver --> Motherboard
Step --> SCL
DIR --> SDA
EN --> A0 (the same pin as the enable on the 4th stepper)
2. Add the attached 3G_6D.xml file to your replicator G machines/ folder.
3. Start Replicator G with the printer disconnected and choose Machine -> Machine Type (Driver) then select: "3G 6D Cupcake (Gen3 XYZ, Mk5/6+Gen4 Extruder)" as your machine. (Make sure in ReplicatorG -> Preferences you have checked: "Show experimental machine profiles".)
4. Connect your bot and restart ReplicatorG
5. Open control panel and make sure the fifth motor works with motor B.
