Thingiverse

Orca 0.3 X-Axis Carriage Belt Clamp T5 / GT2 Belt

Aggresive
299
Downloads
460
Views
Published on January 10, 2012

Description

This sits in-between the two penny washers that are normally used for the clamp.

There are T5 and GT2 versions.

Changed from drawings, now has a cut along the bottom of the part, so that there is space between the part and the x-axis frame.

Instructions

Print 2 off.

Drill out hole to 4.2/4.5mm.

Dismantle x-axis clamps.

Place part in-between the two penny washers.

Fit back onto carriage, rotate parts to align with the belt, and tighten to the carriage.
Tags
This Thing has no tags.
Report as inappropriate

You must be logged in to post a comment.

rolandcube on January 11, 2012 said:

Thanks for this nice piece, this is a good solution so much better than the 2 washers.

Gr. Pascal

Tarjak on January 11, 2012 said:

Also works with Orca 0.2 (tested) ;-)

And by the way, thank you for this :) Helps alot holding the belt in place, and prevents turning of it, while tightening the screws.

Collections

Remixes

Made

Liked by

View all

License

Orca 0.3 X-Axis Carriage Belt Clamp T5 / GT2 Belt by Aggresive is licensed under the Attribution - Share Alike - Creative Commons license.

More from Aggresive

⇪