MendelMax - Adjustable foot - round
by NM-Buzzard, published
A simple 30mm round foot to give your MendelMax a lift.
Print four... one for each corner!
You'll have to temporarily remove one front and one back lower vertex piece to slide in a couple of t-nuts, but that's easy enough. I also added some small foam grippy-pads...
Hardware required :
(4) M5 x 25mm Hex head bolt
(8) M5 Hex nut
(8) M5 Washer
(4) t-slot nuts
Liked ByView All
Give a Shout Out
MendelMax - Adjustable foot - round by NM-Buzzard is licensed under the Creative Commons - Attribution - Share Alike license.
What does this mean?
- You must attribute (give credit) to the creator of this Thing.
- You must distribute Remixes under the same license as the original.
- Remixing or Changing this Thing is allowed.
- Commercial use is allowed.
We're sure NM-Buzzard would love to see what you've printed. Please document your print and share a Make with the community.
To post a Make simply visit this Thing again and click I Made One to start uploading your photo. It’s even easier to post a Make via the Thingiverse Mobile app (available via Google Play and Apple App Store).