Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Y Motor Bracket
21
Likes
518
Downloads
787
Views
Published on January 18, 2012
Description
Inspired by but not derived from thingiverse.com/thing:15602 and thingiverse.com/thing:11017
A Prusa Y Motor Bracket that allows the belt to sit close to the motor face like the X motor, changing forces on the bracket from torsion to compression.
!WARNING! Giant bridge! The entire motor face contacts a bridged area 43x43mm in size. if you haven't dialed in your bridge settings to be capable of 50mm bridges, don't print this until you have!
See my bridge torture test object
A Prusa Y Motor Bracket that allows the belt to sit close to the motor face like the X motor, changing forces on the bracket from torsion to compression.
!WARNING! Giant bridge! The entire motor face contacts a bridged area 43x43mm in size. if you haven't dialed in your bridge settings to be capable of 50mm bridges, don't print this until you have!
See my bridge torture test object
Instructions
No instructions provided.
You must be logged in to post a comment.
License
Y Motor Bracket by triffid_hunter is licensed under the Attribution - Share Alike - Creative Commons license.
More from triffid_hunter
Excellent. Good parametrics too, I am using 36 tooth GT2 pulleys and I had to up the size of the hole a bit - trivial to do. Another excellent Triffid Hunter Mendel improvement. :-$ :-$ :-$
thanks :D
care to post a pic?