Pipette holder for 2 inch bottle
5
Likes
212
Downloads
266
Views
Published on January 15, 2012
Description
I use pipettes a lot when building models and I hate getting them cross contaminated. This handly little holder helps by keeping the pipette with the bottle of solvent or whatever.
PRINT USING PLA!!! The solvent (plastic cement, thinner, etc) will melt ABS but won't melt PLA.
The ring is a oversized slightly to fit over the label on the bottle. If your bottle doesn't have a label, you might need to add a layer of tape to the bottle to get this thing to stay on.
PRINT USING PLA!!! The solvent (plastic cement, thinner, etc) will melt ABS but won't melt PLA.
The ring is a oversized slightly to fit over the label on the bottle. If your bottle doesn't have a label, you might need to add a layer of tape to the bottle to get this thing to stay on.
Instructions
1) Print with PLA ONLY!
2) Slide onto a 2" bottle, place your pipette in the cup and you're ready for action.
2) Slide onto a 2" bottle, place your pipette in the cup and you're ready for action.
License
Pipette holder for 2 inch bottle by Boogie is licensed under the Attribution - Share Alike - Creative Commons license.
More from Boogie
You must be logged in to post a comment.