Arduino Battery Clip
23
Likes
505
Downloads
1127
Views
Published on January 15, 2012
Derived from
Scout - A printable tribot frame
by sliptonic
This thing can be customized with MakerBot Customizer!
Open in Customizer
Description
Screws onto bottom of arduino and attaches 9V battery. useful for anything that should be self-powered. fits UNO, UNO SMD, Duemilanove, Diecimila, NG, most "full-size" clones, MEGA, MEGA 2560
still need to make screw holes bigger, but it should work right now if you drill them out to be the same size as the arduino (1/8")
still need to make screw holes bigger, but it should work right now if you drill them out to be the same size as the arduino (1/8")
Instructions
If your arduino has a screw hole by the power jack, print a Post-UNO model. otherwise, print a Pre-UNO model.
Drill out the screw holes.
Screw it onto your arduino. put in a 9V and your good to go.
Try playing around with the scad file for more options, the method names and parameters are fairly clear.
The thickness and width parameters might not be fully implemented yet.
Drill out the screw holes.
Screw it onto your arduino. put in a 9V and your good to go.
Try playing around with the scad file for more options, the method names and parameters are fairly clear.
The thickness and width parameters might not be fully implemented yet.
You must be logged in to post a comment.
g_rocket
on
January 19, 2012
said:
Removing legs, unnessasary, stands without them
Removing 10mm, huge and clunky and unnessasary
holes were mirrored and in wrong places, fixing that
screw holes still too small, need to be drilled out, will fix that soon
License
More from g_rocket
More from Electronics
I needed a battery holder for my arduino GPS. this works perfect. Thanks