Side RAMPS holder for MendelMax
Published on January 16, 2012
I needed a way to hold my RAMPS electronics down along the side, but I didn't have the foresight to put any extra nuts in the extrusions. So I designed this RAMPS holder that's simply held on using gravity and friction. It uses three M3 screws that must be at least 18 mm long, but you can get away with just using two.
Print everything, then insert the L-shaped clasps into the horizontal holes in the mount. Screw the RAMPS electronics right into the screw holes; they should tap their own threads, so no nuts are needed.