Downloads

Sort By
Date
File Type
Lower Z mount f...stl
170 kb / 77 downloads / 4 months ago
Z-Clamp-on-edge.stl
243 kb / 50 downloads / 4 months ago
Z Clamp.STL
47 kb / 56 downloads / 4 months ago

They Like It

tecnosapiens
C-line
Pawl
DanFineArt
Chucktastic
jebba
mtg5072
austindunk
lshorb

Instructions

Same instructions from the AlephObjects version... you'll need a couple of additional t-nuts in the upper y-axis (side) frame extrusion on each side.

I added a support layer to the rod hole area which needs to be cleaned out before use.

I also added and "on edge" version of the smooth rod clamp for anyone who might prefer printing it that way "for strength" (I haven't seen any problem with those I have which are printed flat, but...)

Z-clamps can use M5 x 20mm screws

Comments