Tweaked Greg's Prusa lm8uu x-carriage
13
Likes
228
Downloads
708
Views
Published on January 21, 2012
Description
I really like Greg Frost's most recent x-carriage but I had a couple ideas that I thought might make it more accessible.
Changes:
1) Added back the other two pairs of mounting holes found on the Prusa sled.
2) Moved the belt clamps in so as to not block the zip-tie slots.
3) Added a bit more width to the belt clamp slots to accommodate slightly wider belts.
4) Made the M3 hole in the tensioning stud a bit tighter & deeper.
Changes:
1) Added back the other two pairs of mounting holes found on the Prusa sled.
2) Moved the belt clamps in so as to not block the zip-tie slots.
3) Added a bit more width to the belt clamp slots to accommodate slightly wider belts.
4) Made the M3 hole in the tensioning stud a bit tighter & deeper.
Instructions
No instructions provided.
You must be logged in to post a comment.
License
Tweaked Greg's Prusa lm8uu x-carriage by Ahasuerus is licensed under the Creative Commons - GNU GPL license.
More from Ahasuerus
How about letting us have access to the scad file too ? Easier to adapt to specific needs.