Small overhang test
11
Likes
377
Downloads
894
Views
Published on January 26, 2012
Description
Small part to test the overhang capability of your 3D printer.
from 30° to 5°
Made with sketchup
The one on the picture is made of ABS and sliced at 0.2mm.
from 30° to 5°
Made with sketchup
The one on the picture is made of ABS and sliced at 0.2mm.
Instructions
No instructions provided.
License
Small overhang test by Petrus is licensed under the Attribution - Share Alike - Creative Commons license.
More from Petrus
Any tips on improving overhang, eg do you print loops before perimeter, and settings for speed/flow rate? Are you slicing with Slic3r or Skeinforge?
Layer Thickness : 0.2mm
W/T : 2.5
Feedrate=Flowrate : 30mm/s
Loops
&
gt;perimeter
&
gt;infill
I am using Skeinforge
To print good overhangs you need a fan that blow air on the printed part, I tried with my fan switched OFF and the result was horrible, even the first step was bad.