SciFi Control Room
67
Likes
548
Downloads
1136
Views
Published on February 3, 2012
This thing was Featured on February 4, 2012
Description
Deck out the top floor of your Makerbot Rocket with this three piece set - it has everything you need to guide your mission to the moon.
For the steering console, chairs, and the rest of the series, check out my other things: thingiverse.com/PrettySmallThings
For the steering console, chairs, and the rest of the series, check out my other things: thingiverse.com/PrettySmallThings
Instructions
Control Tower:
The right and left towers are easily printed with 2 shells (total) and no infill. The arch is best printed on its back as oriented. The geometry is just at the printable limits of my machine without support. Use acetone or glue to adhere together.
Desk:
Print Base & Top with 15-20% infill. The base just exceeds printable limits, but is easily cleaned up. My base print with zero extra shells printed better than the print with one extra shell.
Cabinet:
Print all STLs. Test fit Wall into base & top. Check length of hinge "pins" on doors and trim if necessary. Adhere wall into Base. Drop hinge pins of doors into holes in base. Carefully adhere top to wall, capturing the pins.
Elements are designed to be interchangeable. Create your own layout!
Decorate with your favorite paint medium. My prints are in silver, black and natural ABS with some decorative help from black and silver paint pens + whiteout.
The right and left towers are easily printed with 2 shells (total) and no infill. The arch is best printed on its back as oriented. The geometry is just at the printable limits of my machine without support. Use acetone or glue to adhere together.
Desk:
Print Base & Top with 15-20% infill. The base just exceeds printable limits, but is easily cleaned up. My base print with zero extra shells printed better than the print with one extra shell.
Cabinet:
Print all STLs. Test fit Wall into base & top. Check length of hinge "pins" on doors and trim if necessary. Adhere wall into Base. Drop hinge pins of doors into holes in base. Carefully adhere top to wall, capturing the pins.
Elements are designed to be interchangeable. Create your own layout!
Decorate with your favorite paint medium. My prints are in silver, black and natural ABS with some decorative help from black and silver paint pens + whiteout.
You must be logged in to post a comment.
License
SciFi Control Room by PrettySmallThings is licensed under the Attribution - Share Alike - Creative Commons license.
More from PrettySmallThings
Just what i need for a steampunk submarine cockpit
Thanks! :)