Loading

Minifig

by meetar, published

Minifig by meetar Feb 5, 2012

Description

This is a half-size version of Stefan's double-size minifig, with added attachment posts – you may have to shave the posts to get them to fit.

Recent Comments

view all
Thia is pretty much impossible to print in 1 go
I tried printing this with with support, in PLA at the recommended speed and temp.. Came out dreadful. All the parts had spillover and nothing fit together. Anyone know how I can tweak the printer to print this?

Liked By

view all

License

Minifig by meetar is licensed under the Attribution - Non-Commercial - Share Alike license.

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Print with a raft and exterior support.

The pieces should all fit together without any extra hardware. You may need to widen the joint holes or shave the posts a bit, but a good tight fit is best, and a bit of mushrooming on the posts will also help lock them in and provide friction to hold the limbs in position.

If you print more than a few of these little fellows, be sure to print one of the large ones too, so you'll have someone to settle disputes and provide moral guidance.

Thia is pretty much impossible to print in 1 go
I tried printing this with with support, in PLA at the recommended speed and temp.. Came out dreadful. All the parts had spillover and nothing fit together. Anyone know how I can tweak the printer to print this?
Top