Sort By
HalfBearingInner.stl
35 kb /
90 downloads /
2 years ago
HalfBearingInne...stl
194 kb /
84 downloads /
2 years ago
HalfBearingOuter.stl
39 kb /
84 downloads /
2 years ago
HalfBearingOute...stl
215 kb /
78 downloads /
2 years ago
They Like It
Mostly Printable Ball Bearing - .25 by Corwin is licensed under the Attribution - Share Alike - Creative Commons license.
© 2010 by Corwin
Instructions
Print two of each part.
Put one outer and one inner half on a table concentrically, aligning rods up.
Place 9 of the 6mm balls into the gap between the two pieces on the table.
Place opposing bearing parts onto those on the table in the most obvious possible manner.
Tell me how it went!
