5mm Love Joy Connector
9
Likes
302
Downloads
703
Views
Published on February 7, 2012
Description
Adapt your lovejoy connector to your Nema 17 5mm rod motor. I was sent the wrong one so took the opportunity to create the Love Joy 5mm coupler for the World. Fits perfectly on the 5mm Nema 17 Stepper motors. Fits a M6 Nut and Screw.
Download V2 Version.** Alot Stronger than V1
Download V2 Version.** Alot Stronger than V1
Instructions
1. Download
2. Open in Replicator G or Software.
(I am scaling it to 2515% on Axon 2)
3. Print!
4. Share your Comments and "Like" us on Facebook
facebook.com/mintingmill
Check out my other Creations.
thingiverse.com/MintingMill
2. Open in Replicator G or Software.
(I am scaling it to 2515% on Axon 2)
3. Print!
4. Share your Comments and "Like" us on Facebook
facebook.com/mintingmill
Check out my other Creations.
thingiverse.com/MintingMill
You must be logged in to post a comment.
imitation
on
February 8, 2012
said:
While this should be fine for a NEMA17 motor, i can see it pulling apart its layers where the tabs connect to the base.
You could make a stronger part by printing the tabs separately, with their "fibers" perpendicular to the generated forces, and then solvent-weld them in.
Just my 2ct...
License
5mm Love Joy Connector by MintingMill is licensed under the Attribution - Share Alike - Creative Commons license.
More from MintingMill
V2 Uploaded. Enjoy!