Laser Focus Jig
8
Likes
442
Downloads
703
Views
Published on February 11, 2012
Description
It's a little focus jig used to set up the distance between the lens and the material to cut.
Made from a similar jig observed in use with a Trotec Laser.
Actually used with an HPC Laserscript 6040.
Made from a similar jig observed in use with a Trotec Laser.
Actually used with an HPC Laserscript 6040.
Instructions
Tweak the source file for your setup or if your focus distance is not 41mm.
Cut or Print.
Lower the bed.
Hang the focus-jig on the lens washer.
Rise the bed until the jig fall.
Voilà :)
Cut or Print.
Lower the bed.
Hang the focus-jig on the lens washer.
Rise the bed until the jig fall.
Voilà :)
You must be logged in to post a comment.
More from watsdesign
now all I need is a laser cutter
/J