Thick walled case for equipment PSU's
PSU mounting holes 3mm diameter in a 9.5 x 17.5cm square pattern (check the bottom of your PSU for compatible mounting points)
if you need different mounts then get in touch and I'll share out the Design files.
5mm thick walls, this is a long print :)
Has additional holes for IEC type switch/socket and a 16mm hole to take aviation type 2 pin connector or a panel mount cable grommet.
This is a long print (14 hours on my printer) so double check the measurements for your PSU by importing the STL into a CAD package.
Lid is fixed with M3 screws, you need the countersunk type. Holes in the lid mounting posts are 2.8mm so should provide the right level of bite for M3 screws.