Starcraft 2 Hydralisk
47
Likes
564
Downloads
2625
Views
Published on February 15, 2012
Description
hariseldon wanted one, and I just so happened to have one printed and still had the .stl.
This is a Starcraft 2 Hydralisk. Original model by Blizzard Entertainment, supports, optimization, and base modeled by me.
©2010 Blizzard Entertainment, Inc. All rights reserved. Wings of Liberty is a trademark, and StarCraft and Blizzard Entertainment are trademarks or registered trademarks of Blizzard Entertainment, Inc. in the U.S. and/or other countries.
This is a Starcraft 2 Hydralisk. Original model by Blizzard Entertainment, supports, optimization, and base modeled by me.
©2010 Blizzard Entertainment, Inc. All rights reserved. Wings of Liberty is a trademark, and StarCraft and Blizzard Entertainment are trademarks or registered trademarks of Blizzard Entertainment, Inc. in the U.S. and/or other countries.
Instructions
Print at 20% or so fill, factory settings worked fine for me.
After it prints, you need to use wire cutter or an x-acto knife to remove the supports.
BE CAREFUL, the claws and jaws are very delicate on smaller models (and still delicate on large models), cut slowly and controlled so the thin pieces don't snap.
Clean up spaghetti plastic after print and it should look great.
After it prints, you need to use wire cutter or an x-acto knife to remove the supports.
BE CAREFUL, the claws and jaws are very delicate on smaller models (and still delicate on large models), cut slowly and controlled so the thin pieces don't snap.
Clean up spaghetti plastic after print and it should look great.
You must be logged in to post a comment.
Boluuudo
on
June 23, 2012
said:
Woow... I've been looking for a STL of anything from SC2.
Do you happen to have the model without supports and base?
Excellent work =)
Berend
on
May 10, 2012
said:
Very nice, from what kind of file did you make your .stl ?
Can you post it or tell how to get one ?
I have some small slicing issues and want to make some changes.
Thx
hariseldon
on
February 16, 2012
said:
thank you so much, i'll try to print it this evening, though it seems very difficult.. maybe i'll do some bridge testing before..
License
Starcraft 2 Hydralisk by blueteak is licensed under the Attribution - Share Alike - Creative Commons license.
More from blueteak
Hey Im curious how did you go about extracting the 3d files from starcraft