Texas (trimmed coastline)
Description
I just trimmed the Texas height map to sea level and exaggerated the elevations a bit so it will show up better in your prints.
This was done completely in the Netfabb desktop application. I adjusted the Z axis to remove the ocean water layer and then added a few mm to the Z layer without changing x and y, which stretches out the visible peaks a bit.
This was done completely in the Netfabb desktop application. I adjusted the Z axis to remove the ocean water layer and then added a few mm to the Z layer without changing x and y, which stretches out the visible peaks a bit.
Instructions
No instructions provided.
You must be logged in to post a comment.
License
Texas (trimmed coastline) by 7777773 is licensed under the Attribution - Share Alike - Creative Commons license.
More from 7777773
I messed with taking the excess off with openscad, but just rendering it from the height map was everything my poor laptop could do. I finally had to go to bed. These tiles are 14x14 points.. The next size I made are 120x120.. I also have the original 1200x1200 tiles. There are 84 tiles to make texas.