As some have noticed, the seat on the Versys is tilted forwards just a little bit too much. There are a few remedies for this, from a new seat cover, to using piles of washers to lift the front end of the stock seat. I have come up with what I think, is a low cost yet elegant solution: A 3D printed Riser Block!
As you can see, it lifts the front of the seat up just a little bit (12mm) to give you a much more comfortable ride. I have about 600+ miles on my riser block and it has been holding up great.
I try to use a minimum of 3 layers for the wall, and 3 layers for top and bottom. PLA has been working fine for me so far, but ABS or PET might be better.