Small Magnet Clip
1
Likes
216
Downloads
297
Views
Published on February 18, 2012
Description
This is a small magnet clip that I made to work with the tri-fold screen that I use for displaying my Screenprints at craft shows. It will work on any surface that is approximately 3/16" thick - such as the side of your MakerBot!
Instructions
1. Print it out
2. Run a 1/8" drill bit through hole
3. Press magnet (1/8" x 1/16") into hole
4. Use another magnet to hold your item in place.
2. Run a 1/8" drill bit through hole
3. Press magnet (1/8" x 1/16") into hole
4. Use another magnet to hold your item in place.
You must be logged in to post a comment.
License
Small Magnet Clip by qskapunk is licensed under the Attribution - Share Alike - Creative Commons license.
More from qskapunk
I just realized after printing a bunch of these that it will also work on my Thing-O-Matic.