Loading

Slim LM8UU Holder- Side print version

by Jaknil, published

Slim LM8UU Holder- Side print version by Jaknil Feb 20, 2012

Description

I found that the Slim LM8UU Holder would snap if forced so I adapted it for side printing with super strong results.

Recent Comments

view all

Got it! Uploading! :-D

I'll see what I can do.

I like your stronger approach. Is it easy for you to post a file that can be changed? Im in need of LM12UU holders and widening yours would be quite easy ;)

thanks

Makes

Liked By

view all

Give a Shout Out

If you print this Thing and display it in public proudly give attribution by printing and displaying this tag. Print Thing Tag

Instructions

Download and print! They really are much stronger when you get the filaments along the bend. I added ramps to avoid unnecessary stringing.

If slicing with skeinforge the standard one shell works fine and 30% infill is plenty!

Plausible improvements: I might turn the nut trap so that no bridging is required if I can manage it in the modeler. Stay tuned.

Comments

You must be logged in to post a comment.

waste on Mar 12, 2012 said:

I like your stronger approach. Is it easy for you to post a file that can be changed? Im in need of LM12UU holders and widening yours would be quite easy ;)

thanks

Jaknil on Mar 13, 2012 said:

Got it! Uploading! :-D

Jaknil on Mar 12, 2012 said:

I'll see what I can do.

spad007 on Feb 21, 2012 said:

sHELL'S one?two?three? FILL? 40%?

or more ?? nut traps on the ears not needed? what size nuts?

i will print some going to Slic3r them. see what happens.

thank you

Jaknil on Feb 22, 2012 said:

I used only the one shell since skeinforge has a tendency to skip the infill in thin parts like this one otherwise. And 30% infill was apparently enough. I guess you could try even less since I haven't been able to break the part even when I force it. Don't forget to post feedback!

Top