Paper WindMill (polyhedra-folie)
2
Likes
486
Downloads
441
Views
Published on February 20, 2012
Derived from
Paper WindMill (approach)
by aubenc
Description
I finally decided to change the design, here it is.
Designed to match the dimensions of a windmill made from a 100mm x 100mm piece of paper, two thicknesses: 0.2mm and 0.9mm.
Designed to match the dimensions of a windmill made from a 100mm x 100mm piece of paper, two thicknesses: 0.2mm and 0.9mm.
Instructions
NOT intended to be printed yet!
(ReplicatorG seems that would not find any problem though)
If you like to try anyway use the rawwing or the halfwhatever (and pleeeeease: feedback!)
(ReplicatorG seems that would not find any problem though)
If you like to try anyway use the rawwing or the halfwhatever (and pleeeeease: feedback!)
License
Paper WindMill (polyhedra-folie) by aubenc is licensed under the Attribution - Share Alike - Creative Commons license.
More from aubenc
You must be logged in to post a comment.