Thingiverse

Flex Box - Another one

RobH
2653
Downloads
2659
Views
Published on February 25, 2012

Derived from

Flex Box - A wooden box with a living hinge
by 4volt

Description

Another Flex Box. This is a little bigger than the original but fits on a 12x16 inch laser cutter. It also has tabs to hold it closed. I made this one to hold player tokens for a poker tournament.

Instructions

Put a logo on it and cut on a Laser cutter.
Tags
This Thing has no tags.
Report as inappropriate

You must be logged in to post a comment.

mhsenkow on February 25, 2012 said:

Curious if you have advice, I tried make a modular object with this living hinge, but the hinge was so fragile that that the pieces broke if they were bent much. What sort of wood are you using? (Kind and thickness)

Brian on February 25, 2012 said:

Me agin, Also what settings did you use. I have an Epilog Mini 40W, I am new to this and every time I cut wood it burns the edges and I get black soot all over the place when I touch the wood. Any advice?

RobH on February 25, 2012 said:

The wood is .2 inch thick birch plywood that I covered with strips of wide painters tape on both sides. Using the vector table on my 30W laser the settings were:

Raster 50% speed and 100% power

Vector 30% speed and 100% power 500 frequency

Brian on February 25, 2012 said:

What kind of wood did you use?

merlucin on February 25, 2012 said:

Hi RobH, very nice design, could you give me information about your laser cutter? Is it homemade?

RobH on February 25, 2012 said:

It is an Epilog Zing 16. http://www.epiloglaser.com/zin...

Collections

View all
Thing to Cut
by beardface
Things to Make
by oldschoolghoul
Things to Make
by Getredpanda

Remixes

Made

Liked by

View all

License

Flex Box - Another one by RobH is licensed under the Attribution - Creative Commons license.

More from RobH

⇪