Coin-op Bottle Opener
by hoeken, published
Description
penny-opener.stl - this is the STL for a penny based bottle opener. small, compact, cheap.
quarter-opener.stl - this is the STL for a quarter based bottle opener. bigger, beefier, a bit more expensive.
Recent Comments
view all
I've tried out a good few bottle opener designs over the years. The only one that comes anywhere close to this simple classic in actual effectiveness on a wide range of beers is the "Brain" bottle opener by Ahasuerus http://www.thingiverse.com/thi... so I'm prepared to call this design a classic.
Sounds totally like something I would do, if I were of drinking age.
Nice piece that printed well. I found the NZ 5c coin just a tiny bit big for the penny version. A quick blast on the coin from a blowtorch and it slid into place perfectly (never to leave I suspect).
Given the Kiwi affinity for a beer to celebrate success, this might be my 1st print on new machines to toast their arrival.
Remixed From
Tags
License
Give a Shout Out
Instructions
File Name
Downloads
Size
Comments
You must be logged in to post a comment.
Nice piece that printed well. I found the NZ 5c coin just a tiny bit big for the penny version. A quick blast on the coin from a blowtorch and it slid into place perfectly (never to leave I suspect).
Given the Kiwi affinity for a beer to celebrate success, this might be my 1st print on new machines to toast their arrival.
I got bored while it printed - and opened the beer with pliers. Damn, now I need another beer to test it on...
You should put a hole through it somewhere like the old one, so it can be hung on a wall (also uses slightly less plastic)
I've tried out a good few bottle opener designs over the years. The only one that comes anywhere close to this simple classic in actual effectiveness on a wide range of beers is the "Brain" bottle opener by Ahasuerus http://www.thingiverse.com/thi... so I'm prepared to call this design a classic.