Supportless Kazoo
45
Likes
1031
Downloads
1171
Views
Published on February 26, 2012
This thing was Featured on March 1, 2012
Derived from
Kazoo
by wes
Description
Just a derivate of thingiverse.com/thing:17455 that is printable without support material. It has one additional part. Highest part is 94mm high (a bit less than the original due to possibilities of my mendel...). There are two different sizes of the membrane holder... smaller one works, bigger one still printing printed and working even better than smaller one. due to greater membrane diameter, it seems to work better with lower ferquencies... I would suggest to try the 30mm version.
the picture shows my print in clear PLA (oops some black found its way out the nozzle too...) with the smaller membrane housing.
If you like it, you can check and comment my other designs here: thingiverse.com/elk/things
the picture shows my print in clear PLA (oops some black found its way out the nozzle too...) with the smaller membrane housing.
If you like it, you can check and comment my other designs here: thingiverse.com/elk/things
Instructions
01 - Print Body
02 - Print one of the membran holders
a. "valve inner" and "valve outer" gives all parts needed for a Ø ~20mm membrane
b. "30mm dose", "30mm membranhalter" and "snuffelstucke" gives all parts needed for a Ø ~30mm membrane
03 - Sand away burrs and ooze
04 - assemble and add a piece of Wax-Paper as the Membrane
05 - hum & enjoy :)
PS: do not hum too much around your girlfirend... this will eventually cause dangerous situations ;)
02 - Print one of the membran holders
a. "valve inner" and "valve outer" gives all parts needed for a Ø ~20mm membrane
b. "30mm dose", "30mm membranhalter" and "snuffelstucke" gives all parts needed for a Ø ~30mm membrane
03 - Sand away burrs and ooze
04 - assemble and add a piece of Wax-Paper as the Membrane
05 - hum & enjoy :)
PS: do not hum too much around your girlfirend... this will eventually cause dangerous situations ;)
You must be logged in to post a comment.
thecrazy
on
October 29, 2012
said:
Easy to print if you use a brim on the body. Now I dont know if its only me but it doesn't hum/buzz as much as a store bought kazoo.
Any suggestions?
laird
on
August 11, 2012
said:
This looks very cool. I get an 'access denied' error trying to download the file 'snffe;stcke.stl' though. So I guess I'll print the 20mm version.
License
Supportless Kazoo by elk is licensed under the Attribution - Share Alike - Creative Commons license.
"snffelstcke.stl" seems to be corrupted. So I made the 20 mm version. I used Bakery paper. If i let it loose it works.