T-800 Terminator Exoskull With 5mm holes for led
53
Likes
604
Downloads
2365
Views
Published on February 29, 2012
Derived from
T-800 Terminator Exoskull
by Landru
Description
Same T-800 Terminator Exoskull by Landru but with 5mm holes in the center of the eyes for LEDS
Instructions
Update
----------------------------------------------------------------------------
Some People have been asking about the wire routing & internal supports in the holes. Looking at the Second picture, you can see the Wire trace does pop out the side of the skull. I designed it to allow 4 different places to pull internal supports out of.
---------------------------------------------------------------------------
Print
Remove supports
Add 5mm led to the eyes
Enjoy!
----------------------------------------------------------------------------
Some People have been asking about the wire routing & internal supports in the holes. Looking at the Second picture, you can see the Wire trace does pop out the side of the skull. I designed it to allow 4 different places to pull internal supports out of.
---------------------------------------------------------------------------
Remove supports
Add 5mm led to the eyes
Enjoy!
License
T-800 Terminator Exoskull With 5mm holes for led by 2ROBOTGUY is licensed under the Attribution - Creative Commons license.
More from 2ROBOTGUY
Nice job. It did a great job scaring my kids during the Terminator movies.
I would like to have a metal one printed at shapways.
If anyone prints another one or makes a derivative make the eye holes bigger or scale up a bit.