Circular fan duct for Open X Carriage
22
Likes
482
Downloads
1398
Views
Published on March 5, 2012
Derived from
Circular fan duct for Prusa Mendel
by Ahasuerus
Description
This is the circular fan duct, with extra mounting holes to mount to the side of the Open X Carriage, for those few of us who haven't moved to a Prusa. The top of the funnel is also lowered so as to make room for the belt catch tab.
Instructions
Print, and bolt to the side of your carriage. I replaced the M4 screws holding the bearing arm to the side with longer 30mm screws. I screwed them in from the inside of the carriage and then mounted the top holes in the fan duct to them. The duct is the perfect length to reach a makergear hot end.
You must be logged in to post a comment.
License
Circular fan duct for Open X Carriage by jsadusk is licensed under the Attribution - Creative Commons license.
More from jsadusk
Thanks for this! Right now I just have a fan hotglued between the rails onto the OpenX carriage because I've been too lazy to do exactly what you have done here. Thanks again.