Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
PandaBoard case
6
Likes
1414
Downloads
2083
Views
Published on March 5, 2012
Description
Check this out:
youtube.com/watch?v=vX61U_q6ksg
Tested with the PandaBoard ES, should work with the original PandaBoard aswell (please drop a note if it does/does not. thanks). Contact info on my website: Contact: roland.io/
For 3.2mm material (e.g. wallboard).
Should be tight enough to stay in place without glue!
(Germany: Hartfaserplatte 3.2mm, Bauhaus-Baumarkt)
Note: Version 1.2 has a slighty larger hole for the power connector
youtube.com/watch?v=vX61U_q6ksg
Tested with the PandaBoard ES, should work with the original PandaBoard aswell (please drop a note if it does/does not. thanks). Contact info on my website: Contact: roland.io/
For 3.2mm material (e.g. wallboard).
Should be tight enough to stay in place without glue!
(Germany: Hartfaserplatte 3.2mm, Bauhaus-Baumarkt)
Note: Version 1.2 has a slighty larger hole for the power connector
Instructions
For 3.2mm material (e.g. wallboard).
Should be tight enough to stay in place without glue!
(parts that need to be engraved are red. When using e.g. Epilog, make sure to configure this)
Assemble in this order:
- bottom
- backside
(insder pandaboard, make sure audio jacks fit!)
- right side (RS232/OTG)
- front
- left side
- top.
Done :)
Misc:
- The vector files contain two versions of the front part: One comes with a grill to let air into the case for better cooling, the other one is closed. Please use the one you prefer and that fits the termal profile of your usage.
- It takes approx. 36 minutes to laser + engrave two boxes out of one 600x400m 3.2mm wallboard on a Epilog/Cameo ZING Lasercutter (30 watts)
Should be tight enough to stay in place without glue!
(parts that need to be engraved are red. When using e.g. Epilog, make sure to configure this)
Assemble in this order:
- bottom
- backside
(insder pandaboard, make sure audio jacks fit!)
- right side (RS232/OTG)
- front
- left side
- top.
Done :)
Misc:
- The vector files contain two versions of the front part: One comes with a grill to let air into the case for better cooling, the other one is closed. Please use the one you prefer and that fits the termal profile of your usage.
- It takes approx. 36 minutes to laser + engrave two boxes out of one 600x400m 3.2mm wallboard on a Epilog/Cameo ZING Lasercutter (30 watts)
License
I would like to have the same case, but dont know where I can use lasercutter in Germany.
:'(