Flexion for E3D Retrofit kit bracket for the Smartrapcore series of RepRap printers. This bracket mounts in the same place the normal hotend bracket would be attached with the 4 screws. It holds the Flexion E3D Retrofit kit along with the NEMA17 motor. The Flexion E3D Retrofit kit then holds the E3D V6 or E3D lite6 hotends.
The bracket holds the mounting block of the Flexion Extruder up to allow the motor to be out of the way and does not interfere with any movement or homing. It clears the X motor during a home, and is held away from the belts as to not interfere with normal travel.
I have it fit on my Smartrapcore ALU, but it should fit the Smartrapcore and Smartrapcore 300XL since they all use the same head block.
There is also a version for the E3D V6 (Volcano) that brings the extruder up for the increased length of the Volcano heatblock.
Designed in Onshape
This is a structural part holding a NEMA17 motor. Best when printed with a higher infill for strength.