X endstop holder for MendelMax
4
Likes
88
Downloads
424
Views
Published on March 23, 2012
Description
This part is fairly specific to my build. It is likely it won't work for most other setups.
That said, I used this part with x-ends very similar to Pointedstick's, his x-carriage, and a Wade's (Greg's) extruder.
thingiverse.com/thing:16397
thingiverse.com/thing:16291
Hopefully the pictures make clear what is going on here.
This part is sized to fit the endstops provided at store.mendelmax.com.
That said, I used this part with x-ends very similar to Pointedstick's, his x-carriage, and a Wade's (Greg's) extruder.
thingiverse.com/thing:16397
thingiverse.com/thing:16291
Hopefully the pictures make clear what is going on here.
This part is sized to fit the endstops provided at store.mendelmax.com.
Instructions
Print
Clean part if needed
Insert endstop
Slide onto bolt holding Wade's extruder in place.
Add a washer and a second bolt.
Adjust the endstop in or out as needed.
Adjust the angle of the endstop holder as needed.
Clean part if needed
Insert endstop
Slide onto bolt holding Wade's extruder in place.
Add a washer and a second bolt.
Adjust the endstop in or out as needed.
Adjust the angle of the endstop holder as needed.
License
X endstop holder for MendelMax by Simonious is licensed under the Attribution - Creative Commons license.
More from Simonious
You must be logged in to post a comment.