Wire Holder
7
Likes
289
Downloads
555
Views
Published on March 24, 2012
Description
The Wire Holder is made for taking bundles of wires, and holding them in one place away from a threaded rod.
It measures 32mm x 16mm x 10mm
it has a 10mm cylindrical hole for holding your wires.
It fits on both 8mm and 5/16" threaded and smooth rod.
It also fits zip ties for securing it tightly to rods.
It measures 32mm x 16mm x 10mm
it has a 10mm cylindrical hole for holding your wires.
It fits on both 8mm and 5/16" threaded and smooth rod.
It also fits zip ties for securing it tightly to rods.
Instructions
No instructions provided.
You must be logged in to post a comment.
License
Wire Holder by Acarius10 is licensed under the Attribution - Share Alike - Creative Commons license.
More from Acarius10
More from 3D Printer Accessories
I'm surprised there aren't more comments. I just printed eight of these. They work well to manage my wires. They hold very tightly without cable ties and I like that it is dead simple to remove wires when needed. Thanks for the design!
Thank you very much, for the compliment!