1/4 Acrylic Mount for Foscam FI810W
3
Likes
79
Downloads
474
Views
Published on March 25, 2012
Description
This is a camera mount for a Foscam FI810W Wired/Wirless PT camera. I made it to mount to the slotted angle iron from which my garage door opener is attached. It allows the camera to be mounted below and away from the opener motor without interfering with maintenance on the opener should it be required.
I used 1/4" clear cell cast acrylic; it looks like the camera is levitating because you can't see the mount very well. Use acrylic color and type of your choosing; adjusting power settings as per your laser reccommendations.
It also allows the camera to be mounted low enough to enable vision outside when the garage door is raised.
I hope this simple design is helpful. It will save someone somewhere some time and works well with this sub $100.00 PT IP Camera.
I used 1/4" clear cell cast acrylic; it looks like the camera is levitating because you can't see the mount very well. Use acrylic color and type of your choosing; adjusting power settings as per your laser reccommendations.
It also allows the camera to be mounted low enough to enable vision outside when the garage door is raised.
I hope this simple design is helpful. It will save someone somewhere some time and works well with this sub $100.00 PT IP Camera.
Instructions
Laser cutter settings for 1/4" Acrylic - Epilog Laser 45 Watt settings are 8/100/5000.
1 - Make sure you have an AC outlet within 4 feet of mounting location.
2 - Bolt the mount to the slotted angle iron upon which garage door opener is mounted.
3 - Mount Foscam via included mount.
4 - Secure power cableing with small zip ties to the small holes on the Acrylic mount.
1 - Make sure you have an AC outlet within 4 feet of mounting location.
2 - Bolt the mount to the slotted angle iron upon which garage door opener is mounted.
3 - Mount Foscam via included mount.
4 - Secure power cableing with small zip ties to the small holes on the Acrylic mount.
You must be logged in to post a comment.
License
1/4 Acrylic Mount for Foscam FI810W by GregJB is licensed under the Attribution - Share Alike - Creative Commons license.
That's a great job Mister