100 Watt CO2 Laser Tube Mount
5
Likes
271
Downloads
1553
Views
Published on March 30, 2012
Description
I'm designing this to use on my Scaled up Buildlog.net 2.x Laser, using thingiverse.com/thing:12864 by Mesheldrake.
The tube is pretty long at 100 Watts, so the machine had to be big too.
I've added some anti-warping supports at the base, just in case.
The tube is pretty long at 100 Watts, so the machine had to be big too.
I've added some anti-warping supports at the base, just in case.
Instructions
Designed to mount on 20mm Misumi or 8020 profiles. The tube enclosure on my machine is 80mm wide, and 90mm high. This mount is fastened from the 90mm side.
Print at least three. Trim off the support material around the base.
Use 3-M5 or 1/4" Nylon screws and nuts to secure the tube, but not too tight.
Print at least three. Trim off the support material around the base.
Use 3-M5 or 1/4" Nylon screws and nuts to secure the tube, but not too tight.
License
100 Watt CO2 Laser Tube Mount by wildseyed is licensed under the Attribution - Share Alike - Creative Commons license.
You must be logged in to post a comment.