Downloads
They Like It
Yakima bar end cap with tie-down loop by kevincurry is licensed under the Attribution - Creative Commons license.
© 2010 by kevincurry
Instructions
I created this using Rhino and printed them one at a time on a heated acrylic platform using ABS (about 50 minutes each) and the latest versions of Skeinfox/Skeinforge updated with the settings found at wiki.makerbot.com/configuring-skeinforge
I've been building this 'raftless', but am having trouble doing so on my new kapton covered ceramic platform - the 'loop' wants to pop up which it never did on the acrylic platform - and I hate peeling rafts off the bottom of builds.
Strength was a main concern here, so I wanted the fills pretty solid.
I can fit three of these at once on the build platform and will be trying that soon. I just got my new ceramic heated platform working and will try one on there.
I now have some colored ABS and may try some in colors, but feel as though it may draw too much attention = theft :-)
I recently designed an even bigger/ beefier version (7cm x 4.5cm x 2.5cm) and will post those soon. They're kind of ridiculously large, but kinda cool.
