Oval Gears (Offset)
19
Likes
1944
Downloads
1467
Views
Published on November 29, 2008
This thing was Featured on March 2, 2009
Description
Another non circular Gear
Drawing created using software I found while Googling for Non Circular gears, so credit goes to Jeff Schoner. His website can be found here decidedlyodd.com/cw/cs285/
Drawing created using software I found while Googling for Non Circular gears, so credit goes to Jeff Schoner. His website can be found here decidedlyodd.com/cw/cs285/
Instructions
Cut it out and use 6mm dowel to hold together.
You must be logged in to post a comment.
ssd
on
April 29, 2010
said:
See also the better versions http://www.thingiverse.com/thi... or http://www.thingiverse.com/thi...
Anonymous
on
May 8, 2009
said:
Very cool functional model. I've made a few up using SLS with the company logo.
Single piece construction. No work was required. Pulled straight from the machine and lightly sandblasted, leaving the fully functional set of gears. I can upload the .stl's if anyone would like.
Anonymous
on
December 1, 2008
said:
i cant wait to get back to NYC and cut some of these. very cool.
More from Billion
I was wondering if I actually uses this as a functional gear, would I get undulations of high to low torque? I was thinking of using it for a bug walker because it only needs high torque when it is on the ground and less when it is in the air. Although it may be difficult to keep the gears together.