Arduino Cases
149
Likes
2706
Downloads
4255
Views
Published on April 3, 2012
This thing was Featured on May 21, 2012
Description
Arduino case with two different covers. One cover is low profile for just the arduino. The other cover is for the excellent Video Experimenter shield from nootropic design.
Instructions
This is a minimal plastic usage design. the sides are 1.6mm thick. The hinge is strong with a 3mm hole so you can use plastic filament for the hinge. Of course either top works for the one bottom.
You must be logged in to post a comment.
justjoheinz
on
April 21, 2012
said:
Oh, and if you can, please share the Alibre file. I am using it too, maybe I can design me some improvements.
justjoheinz
on
April 21, 2012
said:
I just printed it with my cupcake, I found that the tolerances are a bit tight and when closing the lid, the bottom part hinge cracked. This is probably also due to the fact that my makerbot is not 100% calibrated. I also just printed it with 24% infill, 100% would probably be better. Having said all that: really nice box!
joeserdynski
on
April 4, 2012
said:
Ahhh! Great idea for using the filiment for the hinge pin! This is what this is all about!
geraldcor
on
April 4, 2012
said:
This is a great design. Would you be willing to upload your source for the Video top so it can be derived to fit with other shields?
License
Arduino Cases by variador is licensed under the Creative Commons - Public Domain Dedication license.
More from variador
More from Electronics
Printed this on a thing-o-matic.. Fits an UNO nice and snug and the ardvidtop had plenty of space for my Wifly shield and the components on top (after I clipped a bit out of the back :) )