Hey! This thing is still a Work in Progress.
Files, instructions, and other stuff might change!
Stepper Motor Mount (nema 17) for 30mm extrusion
3
Likes
95
Downloads
475
Views
Published on April 4, 2012
Description
Just on the off chance you want to do linear motion on 30mm rail.
This one was originally designed to have one on each side of the motor, but I think if I beef it up a bit it'll work fine as a single mount. Look for the beefier version soon.
This one was originally designed to have one on each side of the motor, but I think if I beef it up a bit it'll work fine as a single mount. Look for the beefier version soon.
Instructions
The original design was done in Solidworks but Slic3r didn't like it, but once I ran it through Netfabb Cloud Service (no association) and chose mm even though I rendered it in inches, it fixed it and it prints perfectly.
So slice it in Slic3r, print it with Pronterface.
So slice it in Slic3r, print it with Pronterface.
License
Stepper Motor Mount (nema 17) for 30mm extrusion by DougM is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from DougM
You must be logged in to post a comment.