Crest Spinbursh Toothbrush Holder
2
Likes
250
Downloads
378
Views
Published on April 8, 2012
Description
My wife and I both use Crest Spinbrush toothbrushes but our new bathroom doesn't have a great place to set them. We decided to use a little soap dish alcove but out toothbrushes kept falling over and onto the floor. It was time for a solution. Modeled in OpenSCAD this holder will fit 2 toothbrushes and give them a solid base to not fall over.
Instructions
Print and use.
I have attached the scad file incase you want to adjust it to fit a different model of toothbrush but I didn't really take the time to make it nice and parametric but it's simple enough to figure out.
I have attached the scad file incase you want to adjust it to fit a different model of toothbrush but I didn't really take the time to make it nice and parametric but it's simple enough to figure out.
License
Crest Spinbursh Toothbrush Holder by MattS is licensed under the Attribution - Creative Commons license.
You must be logged in to post a comment.