Wind Barrier/cooler damper
10
Likes
723
Downloads
707
Views
Published on April 9, 2012
Description
This is a redesign of my original model for the windbarrier on the UP! extruder, it redirects a portion of the cooling air down over the part as it is printed allowing the layers to cool faster for more easier support removal (ABS) and less slump (PLA) when going supportless.
I've added a damper bar that can be used to turn off/on the cooling air for those that have sometimes said it was too much for their machines.
I also added a mount point for a Mitutoyo dial test indicator for setting build plate level to nozzle.
I got the original file from, 3dprintingsystems.com/support/
I remodeled it in SolidWorks 2010.
I've added a damper bar that can be used to turn off/on the cooling air for those that have sometimes said it was too much for their machines.
I also added a mount point for a Mitutoyo dial test indicator for setting build plate level to nozzle.
I got the original file from, 3dprintingsystems.com/support/
I remodeled it in SolidWorks 2010.
Instructions
Print both parts and add a M2 x 16 lg SHCS.
If you get too much warp/lift or layer seperation close damper by turning screw.
If raft and support are too tough to remove open damper.
If you get too much warp/lift or layer seperation close damper by turning screw.
If raft and support are too tough to remove open damper.
License
Wind Barrier/cooler damper by DrewPetitclerc is licensed under the Attribution - Non-Commercial - Creative Commons license.
More from DrewPetitclerc
You must be logged in to post a comment.