iPhone Bumper
Description
iPhone 4/4S Bumper
Instructions
Successfully printed at .25mm layer height, 50mm/s, 10%
You may get some very minor overhang strands on the top part that can be pulled off after printing.
You may get some very minor overhang strands on the top part that can be pulled off after printing.
You must be logged in to post a comment.
tidder11
on
April 20, 2012
said:
Printed using slic3r with 1 perimeter and 10% infill. Had it doing some wier infill in the middle or bridges.. so wasnt actually just the border. had a layer printed in about half way up the z axis. Ideas?
chaffeem
on
April 18, 2012
said:
I tried printing it and it was slightly too large in length and the other direction was a little bit loose. With some minor tweaks though this will be very nice. Maybe the back will help make a tight fit. I'm trying that version now.
License
More from nickfabb
I tried printing it with a Ultimaker with an Extruder Upgrade and I am having the same problem as chaffeem. Soem minor tweaking and It'll be perfect.