Ultimaker printhead cover
43
Likes
798
Downloads
2559
Views
Published on April 11, 2012
Description
Printhead cover to protect the wires on top of the Ultimaker printhead
Instructions
Print as provided. I used 0.2mm layers
The cover has tiny overhanging edges at the end that snap over the wooden plate. Once in place it sits very firmly around the printhead.
Weighs about 19 grams (printed in Cura with 25% rectangular infill and 3 solid layers)
There is just enough room to slide over the X-axis blocks
The cover has tiny overhanging edges at the end that snap over the wooden plate. Once in place it sits very firmly around the printhead.
Weighs about 19 grams (printed in Cura with 25% rectangular infill and 3 solid layers)
There is just enough room to slide over the X-axis blocks
You must be logged in to post a comment.
Cinezaster
on
September 20, 2012
said:
With the new extruder the printerhead is not been able to go over the wooden plate because of the height of the temperature sensor.
Gijs
on
May 2, 2012
said:
Just found that there is some risk that the cover damages the cloth around the heater wire :(
So take care and make sure the wire can move freely without friction against the cover!
bbum
on
April 22, 2012
said:
Can you upload the original file? I need to knock out part of one side for some cable action.
More from Gijs
More from 3D Printer Accessories
I had to scale the Z-axis about 120% to fit perfect.