Ramps 1.4 Box
59
Likes
1173
Downloads
3881
Views
Published on April 14, 2012
Description
I thing this case for my 1.4 Ramps , I looks nice to share it with you . Bye
Instructions
Print the bottom part with the base to the vertical Z axis , while the top cover print with the base to the bed . I set the speed to 25mm/s , with the infill in rectilinear mode at 100% . The interlocking of the pieces is dovetail , with a little screw in the bottom .
You must be logged in to post a comment.
bobby2sox
on
July 24, 2012
said:
Thank you! I printed this and http://www.thingiverse.com/thi... and mounted this box on that plate in the back left corner of my printer...
I used some braided wire covering and wish that there was a little more space to fit all of my wires in there... its a tight squeeze.
Keavon
on
May 28, 2012
said:
Nice! I like how it looks like a video card... sadly I use RAMPS 1.2, so I'm going to try modifying it to fit. Also I only have white PLA, so it won't look as good...
rcboosted
on
April 15, 2012
said:
Nice box! Do you have openscad files? If so would you mind posting that? I want to use a 60mm fan.
More from oTTo
As a RepRap newbie I'm taking a little survey, and I'm curious to know… Where did you connect up the power to your electronics cooling fan? The build area fan is usually wired to D9, so it's not clear where to connect up a second fan on RAMPS (1.4). What was your personal solution?