Masson jar lamp by Samuel Bernier, Project RE_
35
Likes
188
Downloads
1047
Views
Published on April 15, 2012
Description
An other cool way to reuse a Masson jar using an IKEA suspension kit and funky 3D printing.
More about Project RE_ on instructables.com/id/Project-RE-by-Samuel-Bernier/
More about Project RE_ on instructables.com/id/Project-RE-by-Samuel-Bernier/
Instructions
All you will need is a 3 inches wide glass jar (lid size), the 6$ IKEA suspension kit, a light bulb and this file.
Print the shade, the bigger opening facing the table. Set the support angle to 30 degrees. The part takes about 3 hours to print in normal mode. 0.25 thickness.
Then pass the cable trough the hole, screw the light bulb and then screw the cleaned jar. You got the lamp!
-Sam
Print the shade, the bigger opening facing the table. Set the support angle to 30 degrees. The part takes about 3 hours to print in normal mode. 0.25 thickness.
Then pass the cable trough the hole, screw the light bulb and then screw the cleaned jar. You got the lamp!
-Sam
License
Masson jar lamp by Samuel Bernier, Project RE_ by samuel is licensed under the Attribution - Creative Commons license.
You must be logged in to post a comment.